Full 303 Practice Test and 533 Unique Questions, Get it Now!
The Best 303 Exam Study Material Premium Files and Preparation Tool
NEW QUESTION # 295
AN LTM Specialist is using an external monitor evaluate the hard drive usage of a node. The monitor has marked the node down because it exceeded the specific threshold. The disk usage on the server has been corrected below the threshold, however, the node remains offline.
Which feature is causing this problem?
- A. The value for Manual Resume is set to Yes
- B. The value for UP interval is enable with a value greater than 0
- C. The parameter Time Until UP has a value greater than 0
- D. The value of Manual Resume is set to No
Answer: A
NEW QUESTION # 296
Refer to the exhibit. How many nodes are represented on the network map shown?
- A. Four
- B. One
- C. Three
- D. Two
Answer: C
NEW QUESTION # 297
An LTM device pool has suddenly been marked down by a monitor. The pool consists of members
10.0.1.1:443 and 10.0.1.2:443 and are verified to be listening. The affected virtual server is 10.0.0.1:80.
Which two tools should the LTM Specialist use to troubleshoot the associated HTTPS pool monitor via the command line interface? (Choose two.)
- A. ssldump
- B. tcpdump
- C. telnet
- D. curl
Answer: A,D
NEW QUESTION # 298
An LTM Specialist is troubleshooting a problem on an eCommerce website. The user browses the online store using port 80, adding items to the shopping cart. The user then clicks the
"Checkout" button on the site, which redirects the user to port 443 for the checkout process.
Suddenly, the user's shopping cart is shown as empty. The shopping cart data is stored in memory on the server, and the default source address persistence profile is used on both virtual servers. What is the issue?
- A. The port 443 pool member is deleting the user's session cookie.
- B. The port 80 pool member is deleting the user's session cookie.
- C. The port 80 and port 443 connections are balanced to the same node.
- D. The port 80 and port 443 connections are balanced to different nodes.
Answer: D
NEW QUESTION # 299
Some users who connect to a busy Virtual Server have connections reset by the BIG-IP system. Pool member resources are NOT a factor in this behavior. What is a possible cause for this behavior?
- A. The Rewrite Profile has NOT been configured.
- B. The Connection Limit is set too low.
- C. The Connection Rate Limit is set too high
- D. The server SSL Profile has NOT been reconfigured.
Answer: B
Explanation:
Explanation
The topic explains that the connection reset behavior is caused by the vs configuration rather than the server resource problem. The answers B C are all configuration at the service forwarding level. If there is a problem with the configuration, it is all a problem rather than some users. Answer C's Connection Limit will cause a reset behavior when the connection reaches the threshold.
NEW QUESTION # 300
Refer to the exhibit. Based on the output of the tmsh interface show command, what is the issue?
- A. There are too many drops on inbound traffic on interface 1.1.
- B. Flow Control is NOT configured on the management interface.
- C. There is a duplex mismatch on the management interface.
- D. Interfaces 2.1 and 2.2 are defective and need replacement.
Answer: C
NEW QUESTION # 301
An IT support engineer needs to access and modify Virtual Servers in three partitions (Common /Banking and Dev) daily on a BIG-IP device. The company operates a Least Privilege access policy. What level of access does the IT support engineer need to ensure completion of daily roles?
- A. Manager in all partitions
- B. Application Editor in /Common, /Banking, and /Dev partitions
- C. Manager in /common/Banking, and /Dev partitions
- D. Application Editor in all partitions
Answer: C
NEW QUESTION # 302
The BIG-IP appliance fails to boot. The BIG-IP Administrator needs to run the End User Diagnostics (EUD) utility to collect data to send to F5 Support.
Where can the BIG-IP Administrator access this utility?
- A. Console Port
- B. Management Port
- C. External VLAN interface
- D. Internal VLAN interface
Answer: A
NEW QUESTION # 303
Users report that traffic is negatively affected every time a BIG-IP device fails over. The traffic becomes stabilized after a few minutes.
What should the BIG-IP Administrator do to reduce the impact of future failovers?
- A. Configure MAC Masquerade
- B. Set up Failover Method to HA Order
- C. Enable Failover Multicast Configuration
- D. Configure a global SNAT Listener
Answer: A
NEW QUESTION # 304
Refer to the exhibit.
An LTM Specialist has multiple SNAT and virtual server objects configured as in the bigip.conf shown.
The LTMSpecialist tests a connection from a client with. IP 172.163.31.11 to 192.168.0.100:80.
Which two objects will show an increase in Local Traffic statistics connections?
- A. VS_B&SNAT_B
- B. VS_A & SNAT A
- C. VS_A&SNAT_B
- D. VS_ B & SNAT A
Answer: C
NEW QUESTION # 305
An LTM Specialist configures the following iRule on an LTM device:
when HTTP_REQUEST {
if {[string tolower [HTTP::uri]] contains "/URI1/" } {
pool Pool1
}
elseif {[string tolower [HTTP::uri]] contains "/URI2/" } {
pool Pool2
}
elseif {[string tolower [HTTP::uri]] contains "/URI3/" } {
pool Pool3
}
else { pool Pool4}
}
Given
the following request: http://www.example.comURI1/index.html?fu=bar
&pass=1234
Which pool will be selected by the iRule?
- A. Pool1
- B. Pool2
- C. Pool4
- D. Pool3
Answer: C
NEW QUESTION # 306
A BIG-IP Administrator needs to configure the BIG-IP system to perform load balancing for FTP servers running passive mode FTP.
How should the administrator configure the Virtual Server to perform this load balancing?
- A. A Performance Layer 4 Virtual Server + FTP profile
- B. A Standard Virtual Server + FTP profile
- C. A Message Routing Virtual Server
- D. A Forwarding Virtual Server
Answer: B
NEW QUESTION # 307
Refer to the exhibit. According to the shown Configuration Utility stings What is the setting of the User Directory configuration under the Authentication submenu?
- A. Local
- B. Default system configuration
- C. Remote-TACACS+
- D. Managed
Answer: C
NEW QUESTION # 308
-- Exhibit -
-- Exhibit --
Refer to the exhibits.
Users are able to access the application when connecting to the virtual server but are unsuccessful when connecting directly to the application servers. The LTM Specialist wants to allow direct access to the application servers.
Which configuration change resolves this problem?
- A. Configure a route to the web server subnet on the network router.
- B. Configure a SNAT pool on the LTM device.
- C. Enable port 443 on the virtual server.
- D. Disable address translation on the virtual server.
- E. Configure an IP Forwarding virtual server on the LTM device.
Answer: E
NEW QUESTION # 309
Which log file should the BIG-IP Administrator check to determine if a specific user tried to log in to the
8IG-IP Configuration by utility?
- A. /var/log/pam/tally/log
- B. /ver/log/secure
- C. /var/log/trn
- D. /var/log/http.d
Answer: B
NEW QUESTION # 310
......
F5 303 certification exam consists of 80 multiple-choice questions that must be completed in two hours. 303 exam covers a wide range of topics, including application security management, web application vulnerabilities, and the deployment and configuration of F5 BIG-IP ASM. To pass the exam, candidates must score 69% or higher.
Get Instant Access to 303 Practice Exam Questions: https://www.exams-boost.com/303-valid-materials.html
Reliable Study Materials & Testing Engine for 303 Exam Success!: https://drive.google.com/open?id=1Adr2d7j6KdQQ5E79j_XFLslK8ST3ODq-