HCNP-LTE RNP & RNO H35-561-ENU Dumps | Updated Dec 16, 2021 - Exams-boost
Master 2021 Latest The Questions HCNP-LTE RNP & RNO and Pass H35-561-ENU Real Exam!
NEW QUESTION 29
Measuring GAP is the time period of measuring the UE leave the current frequency point to other frequency points.
- A. True
- B. False
Answer: A
NEW QUESTION 30
Which of the following is used to uniquely identify the UE corresponding to the S1 interface in the same eNB?
- A. MME UE S1AP ID
- B. C-RNTI
- C. New eNB UE X2AP ID
- D. eNB UE S1AP ID
Answer: D
NEW QUESTION 31
How many symbols can the UpPTS occupy in a special time slot? (Multiple choice)
- A. 0
- B. 1
- C. 2
- D. 3
Answer: A,D
NEW QUESTION 32
Regarding the T300 timer, which of the following description is wrong?
- A. Turn on when sending RRCConnectionReestabilshmentRequest message
- B. The upper layer stops when receiving RRCConnectionSetup or RRCConnectionReject information.
- C. Turn on when sending RRCConnectionRequest message
- D. Clear the MAC after the timer expires, release the MAC configuration, and rebuild the RLC.
Answer: D
NEW QUESTION 33
Which of the following scheduling algorithms can guarantee the fairness of each user in the cell?
- A. RR (Round Robin)
- B. Max C/I
- C. EPF (Enhanced Proportion Fair)
- D. PF (Proportional Fair)
Answer: A
NEW QUESTION 34
Which of the following are the information elements contained in the RRC Connection Reconfiguration message? (Multiple choice)
- A. Wireless resource configuration
- B. NAS security parameters
- C. Mobile control information
- D. Measurement configuration
Answer: A,B,C,D
NEW QUESTION 35
RB is the smallest resource granularity in the LTE system.
- A. True
- B. False
Answer: B
NEW QUESTION 36
The "average number of uplink PRB resource usage" counts the number of RBs used by the uplink PUSCH.
- A. True
- B. False
Answer: A
NEW QUESTION 37
Which of the following RNTIs use fixed values? (Multiple Choice)
- A. SI-RNTI
- B. SPS-RNTI
- C. P-RNTI
- D. C-RNTI
Answer: A,C
NEW QUESTION 38
The single-station verification test only needs to verify whether the cell status in the idle mode is normal.
- A. True
- B. False
Answer: B
NEW QUESTION 39
Suppose the PCI of cell A is 6, and 2*2 MIMO is used. Which of the following neighboring cells are also 2*2 MIMO that will cause modulo three interference with cell A?
- A. PCI=24 cell
- B. PCI=31 cell
- C. PCI=19 cell
- D. PCI=18 cell
Answer: A,D
NEW QUESTION 40
When the test is terminated, the MS call or data service connection must be stopped first, then the test plan is stopped, and finally the Logfile is stopped and the external device is disconnected.
- A. True
- B. False
Answer: A
NEW QUESTION 41
What is the maximum number of HARQ processes supported by the LTE FDD mode?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: C
NEW QUESTION 42
Regarding the maximum rate of UE in 20M bandwidth TD LTE under different modes, which of the following description is correct?
- A. TM3 > TM8 > TM2 > TM7
- B. TM2<TM3<TN7<TM8
- C. TM3=tm8>TM2=TM?
- D. TM3>TM8>TM7>TM2
Answer: A
NEW QUESTION 43
Event B1 indicates that the paging quality of the heterogeneous neighboring cell becomes higher than the corresponding threshold.
- A. True
- B. False
Answer: A
NEW QUESTION 44
In SAE, which of the following entity use to deal with the control plane of S1 interface?
- A. PDN GATEWAY
- B. PCRF
- C. MME
- D. SGW
Answer: C
NEW QUESTION 45
Which of the following options is not the cause of ERAB abnormal release?
- A. Wireless link failure
- B. Transport layer failure
- C. Cell congestion
- D. The UE inactivity timer expires and enters the Idle state.
Answer: D
NEW QUESTION 46
Which of the following is not a characteristic can be used to automatically increase the adjacent areas?
- A. PCI collision detection
- B. Massive MIMO
- C. ANR
- D. MRO
Answer: C
NEW QUESTION 47
Which is the wrong descriptions of LTE signal quality?
- A. The higher the average value of CQI, the better the signal quality
- B. UE can report the quality of each PRB alone
- C. The MCS value is assigned by the MME and indicates the quality of the Uu interface.
- D. The higher the CQI value, the better the signal quality.
Answer: B,C,D
NEW QUESTION 48
What are the types of switching according to the trigger reason? (multiple choice)
- A. Handover based on UE moving speed
- B. Load-based handover
- C. Overlay-based handover
- D. Business-based handover
Answer: A,B,C,D
NEW QUESTION 49
Which of the following modules does the AAU function module include? (Multiple Choice)
- A. RU
- B. Power Module
- C. AU
- D. CU
Answer: A,B,C
NEW QUESTION 50
......
A fully updated 2021 H35-561-ENU Exam Dumps exam guide from training expert Exams-boost: https://www.exams-boost.com/H35-561-ENU-valid-materials.html